Mercedes-Benz E 350
Four-valve V6 with variable valve timing. Smooth and powerful. Known for balance shaft wear (revision sprocket) on early build years. Balance shaft gear problem addressed by Mercedes with a recall.
Solid Basis
200 kW — everyday-capable power, without excitement.
Engine Weaknesses 6
The plastic balance shaft sprocket on the M272 wears prematurely from the timing chain. The right cylinder bank goes out of timing. Affected up to end of October 2006.
Symptoms: Fault codes P0016/P0017 (camshaft right bank), chain rattling, rough running at idle, in extreme cases engine damage
Alongside the balance shaft issue the M272 shows premature timing chain stretch. Chain wear on softer sprockets leads to timing deviations.
Symptoms: Chain noise especially on cold start, camshaft fault codes, rough running, engine irregularities
Four camshaft adjuster solenoids (two per cylinder bank) develop leaks; oil creeps into the wiring harness as far as the ECU. Repair costs up to €1,700 documented.
Symptoms: CEL, oil traces at camshaft connectors, lambda sensor failure due to oil contamination, non-specific faults that recur
Plastic components of the M272 variable intake system become brittle and break. The intake flap linkage snaps and sets fault code P2006.
Symptoms: Fault codes P2004/P2005/P2006 (intake flap), slight power loss, check engine light
The thermostat on the M272 preferentially fails in the open position. Operating temperature is not reached; especially on motorway runs temperature drops to 75–80°C.
Symptoms: Engine doesn't reach 90°C after 10–20 km, coolant temperature fluctuates heavily, reduced heater output, fault code P0128
The hydraulic engine mounts on the M272 lose their damping effect with age. Jerky movements are especially apparent when lifting off the throttle and during gear changes.
Symptoms: Vibrations in steering wheel and gear lever during load changes, judder on gear changes, droning at low revs
Vehicle Weaknesses 6
Sensotronic Brake Control on pre-facelift models (2002–2006) suffered hydraulic failure. Approximately 1.3 million vehicles were recalled worldwide. Repair cost €2,200–3,500.
The Signal Acquisition and Actuation Module (SAM) fails, particularly when water ingress occurs. Leads to loss of lighting, windscreen wipers and instrument cluster.
SBC electrohydraulic brake (2002–2006) suffered from faulty high-pressure pump control. Two recalls in 2004 and 2005. SBC vehicles require specialist workshop.
AIRMATIC air suspension wears heavily. Air reservoir and compressor fail frequently. Replacement requires complete rear axle disassembly — very costly.
Control arm and track rod end bearings develop play. A common MOT failure point. Regular cause for failed MOT inspection.
SAM modules (front and rear) control lighting, wipers and door functions. Moisture damage and ageing lead to complete failures.