Mercedes-Benz S 500
Naturally aspirated V8 in three displacements from 4.3 to 5.5 litres — old-school character with no turbo lag. Linear power delivery, deep rumble from 2,000 rpm building to a hoarse roar above 5,000. Peak torque at 3,000; beyond that it thins out — yet it's silky in part-throttle and surprisingly economical. Achilles heel is the seals: rear crankshaft oil seal practically universal above 150,000 km (gearbox removal required, 600–900 EUR), valve covers and oil filter housing seep with age. All cheap parts. The one critical point: the rubber damper on the crankshaft pulley hardens with age — when it fails the pulley machines into the sump. Replace preventively every 150,000 km. Oil changes every 10,000 km with 5W-40, 16 spark plugs every 60,000–80,000 km — then 400,000 km is realistic.
V8 Long-Hauler — the M113 in Its Element
306 hp V8 in the benchmark saloon of the 2000s. The M113 E50 drinks 10–11 L/100 km on the motorway at 140 — remarkable for a V8. At full throttle it pushes two tonnes effortlessly to 250. Engine is the least of the car's problems — Airmatic, Comand system and wiring harness ageing eat the budget. Buy only with fully documented service history.
Engine Weaknesses 10
The rubber damper in the crankshaft pulley hardens with age and can eat into the sump — catastrophic consequential damage. Preventive replacement every 150,000 km strongly recommended.
Symptoms: Unusual vibrations at idle, in worst case metallic scraping from below. Often no prior warning — sudden failure.
The rear crankshaft seal is leaking on virtually all M113 engines above 150,000 km. Gearbox removal required — 600–900 EUR workshop costs. If oil creeps into the torque converter it becomes expensive.
Symptoms: Oil drops or oil film visible at the engine-gearbox interface, oil loss without any other apparent leak on the engine.
Engine mounts can fail before 100,000 km. Practical test: finger between the stabiliser bar and front sump — no clearance means the mount is dead. Not visually checkable without removal.
Symptoms: Vibrations in interior especially at idle, dull rumbling on acceleration, in worst case contact between engine and bodywork.
Faulty thermostat leads to permanently low engine temperature (increased wear) or overheating in traffic jams. Part costs 24 EUR — swap it immediately on suspicion, do not wait.
Symptoms: Temperature gauge permanently below mid-point (thermostat opens too early) or engine overheats in traffic (thermostat stuck closed).
The front crankshaft seal hardens with age. More accessible than the rear seal, but the pulley bolt is a single-use part. Oil on the drive belt damages it additionally.
Symptoms: Oil film on underside of belt drive, oil visible on drive belt.
Both valve cover gaskets harden with age and allow oil through. Cheap parts (18 EUR each), but caution: aluminium bolts on the valve cover — no over-torque or the threads strip.
Symptoms: Oil smell in engine bay, visible oil film on lower valve cover edge, smoke when oil drips onto exhaust manifold.
PCV hoses become brittle and crack. Leads to pressure increase in the crankcase, elevated oil consumption and false air ingestion. All hoses together under 31 EUR — worth replacing as a set.
Symptoms: Elevated oil consumption without visible leak, white smoke from exhaust, idle fluctuations from false air.
O-ring seals on the oil filter housing and oil cooler connection harden and seep oil. Classic ageing, cheap to fix if caught early — all three seals under 30 EUR.
Symptoms: Oil film around the oil filter area, drips under the vehicle at the front of the engine.
The bolts on the intake manifold switchover loosen. They cannot fall out but cause noise and functional disturbance. Recommendation: remove intake tract, clean, secure bolts with Loctite.
Symptoms: Clattering or rattling from the intake area, irregular throttle response, slight power drop at certain rpm.
The 16 original injectors (black) wear at high mileage. Mercedes introduced revised blue injectors. O-ring seals on the injectors can leak and allow fuel into the oil.
Symptoms: Elevated fuel consumption, idle fluctuations, fuel smell on dipstick from leaking O-rings.
Vehicle Weaknesses 6
The Airmatic compressor runs continuously when there are leaks in the system and burns out. Without swift intervention, total suspension failure and blocked ride-height control follow.
Air spring bag seals age and become leaky. The vehicle drops on one side or completely. All four struts typically need replacement by around 250,000 km.
Three SAM modules in the engine bay and interior are vulnerable to water ingress through blocked drain channels. Secondary damage can exceed the vehicle's residual value.
The hollow-section sills of the W220 rust from the inside out. Nothing is visible externally for a long time until the rust is already well advanced. Pre-facelift models (1998–2002) are particularly affected.
The W220 rusts at the underbody, wheel arches and weld seams, particularly where underbody protection has not been renewed regularly.
Electric window regulators are not rated for the weight of the W220 double-glazed windows and wear out prematurely. Driver's side particularly affected.
Reports & Tests
289 owner complaints filed with NHTSA (1998–2005). Most reported: Electrical (108), Suspension (68), Lighting (24).