Seat Leon Cupra 2.0 TFSI 240
The EA113 with 200 hp in the Leon Cupra 1P has a punchy, characterful delivery but is no maintenance-free engine. The HPFP camshaft lobe wears if servicing is neglected; watch oil consumption from 150,000 km onwards. Full service history is non-negotiable when buying.
240 hp Cupra — the Big Bang
The BWJ with 240 hp in the Leon 1P was the beginning of the Cupra legend. Raw, direct and uncompromisingly fast.
Engine Weaknesses 4
The EA113 BWJ (200 hp) shares the worn cam follower problem of the high-pressure pump with the BWA. The higher power output increases thermal stress. Without replacement, engine and turbo run on insufficient fuel pressure.
Symptoms: Power loss at full throttle, rough running, engine warning light for rail pressure fault code
All EA113 TFSI engines including the BWJ are affected by cam follower wear. Repair after full failure costs over €3,000 as the timing chain and valves can also be damaged.
Symptoms: Fuel pressure fault code, engine stuttering on acceleration, in extreme cases engine damage
Even the highest-output EA113 BWJ (Leon Cupra 1P) shows oil consumption at high mileage from piston ring and valve stem seal failure. On sportily driven examples, appearing earlier.
Symptoms: Dropping oil level, blue smoke on acceleration or cold start
EA113 TFSI engines in BWJ trim burn excessive oil through clogged oil scraper ring drillings. Real-world figures often far exceed VW's 0.5 l/1,000 km tolerance at higher mileage.
Symptoms: Oil level drops rapidly, fine blue smoke from exhaust, consumption well above 0.5 l/1,000 km
Vehicle Weaknesses 7
The early TSI engines (1.2 TSI, 1.8 TSI) in the Leon 1P generation have a vulnerable timing chain. From around 100,000 km it starts to stretch and rattles particularly on cold starts.
Leaking body seals cause water ingress in the footwell and boot on older Leon 1P examples. Professional resealing is required to prevent subsequent rust damage.
TDI engines in the Leon 1P develop hairline cracks in high-pressure fuel lines at high mileage, and direct injection causes carbon build-up on injectors.
The exhaust system on the Leon 1P rusts through prematurely. Brake hoses also degrade over time and can attract roadworthiness inspection complaints.
Brake discs and pads wear faster than average. Defective brake hoses are a roadworthiness inspection complaint on older 1P models.
Headlight failures and brake light defects are typical complaints on the Leon 1P. Minor electrical faults accumulate as the car ages.
The climate system in the Leon 1P gradually loses refrigerant through ageing seals. The condensate drain hose on the passenger side can crack and route condensation into the cabin.
Reports & Tests
The second Leon generation shows the weakest roadworthiness inspection results of all Leon generations: defective timing chains in TSI engines, dual-clutch gearbox problems, and increased brake disc wear frequently occur together.
