Mercedes-Benz AMG S 65
Hand-built in Affalterbach to the One Man, One Engine principle — plaque with signature on the cam cover. Architecture: two separate six-cylinder banks, SOHC, three valves per cylinder (2 intake, 1 exhaust), derived directly from the M120 V12. 1,000 Nm from 2,300 rpm, electronically limited — the actual mechanical torque is estimated at 1,200 Nm. Dual ignition with 24 spark plugs, four catalytic converters (one pre-cat and one main cat per bank). At idle at 600 rpm virtually vibration-free — a deep, silky rumble. At full throttle a baritonal-metallic hiss that expands into a roar. No turbo lag: the torque plateau is so wide that boost build-up is barely perceptible. At 130 km/h the engine turns at approximately 1,700 rpm. 12.7 litres of oil capacity, major service from 1,500 EUR, 24-plug change from 900 EUR. ABC system overhaul can run into five figures. Maintained properly, one of the most effortlessly capable powerplants available.
Hand-Built V12 in the Finest Coupé of Its Time
Two fewer doors, more of a grand touring statement. Same engine, same 1,000 Nm, but the C217 body looks tauter and more sporting than the saloon. Lower seating position, stiffer bodyshell, frameless windows. Anyone stepping in here does not want a company car — they want the definitive V12 coupé.
Engine Weaknesses 12
The M279 uses two fully potted ignition module banks for six cylinders each. Not repairable — replacement only. Failure documented from 60,000–100,000 km. Labour time is high due to tight packaging in the V-valley.
Symptoms: Misfires on one cylinder bank, rough running, power loss, check engine light with ignition fault code.
Both turbochargers wear at their bearing surfaces at high mileage. Replacing both turbos on the V12 requires extensive disassembly. Parts and labour costs run into five figures.
Symptoms: Metallic whine under load, oil loss at turbo mounting, power drop, blue smoke at full throttle.
The oil cooler sits centrally in the V-valley between the cylinder banks. The gasket becomes brittle under temperature cycling. Complete failure risks oil-coolant emulsification and overheating. Access is labour-intensive due to intake system removal.
Symptoms: Oil weeping visible in V-valley, possible oil-coolant emulsion on dipstick, oil smell after engine shutdown, coolant discolouration.
The Active Body Control system hydraulic lines become brittle over time. Leaks at fittings and line ends cause hydraulic fluid loss. Oil on hot components creates a fire risk.
Symptoms: Hydraulic fluid under the vehicle, uneven ride height, ABC warning in the instrument cluster.
The ABC hydraulic pump and valve block wear at high mileage. On the SL65 the pump alone takes around 13 hours to remove. A full system overhaul comes to €10,000–15,000.
Symptoms: ABC visit workshop warning, vehicle drops on one or all corners, stiffer suspension, hydraulic fluid loss.
The camshaft adjuster solenoids can leak. Oil migrates through the wiring harness to the ECU. A creeping defect: first cold-start rattle, later ECU failure.
Symptoms: Rattle on cold start that fades after a few seconds, rough running during warm-up, camshaft fault codes.
The gearbox was electronically limited to 1,000 Nm — the actual engine torque is higher. Torque converter and AMG-specific TCU wear under this constant load. Shift times under 100 ms stress the mechanicals.
Symptoms: Delayed pull-away, jerky gear changes, transmission warning, limp mode.
The stock plastic bypass valves on the compressor covers become leaky over time. Power loss and audible hissing result. Metal replacements are available and recommended.
Symptoms: Hissing on lift-off, power drop under higher load, rough running during boost build-up, boost pressure regulation fault codes.
Mercedes defines 1 litre per 1,000 km as normal for AMG engines. With the V12's 12.7-litre oil capacity and two turbochargers that can become relevant quickly. Valve stem seals and turbo shaft seals are the main culprits.
Symptoms: Dropping oil level between service visits, faint oil-burn smell after motorway runs, occasional blue smoke on cold start.
The hydraulically damped engine mounts harden at higher mileage. On the SL65, the replacement involves up to 25 hours of labour due to a different mounting arm design. Considerably simpler on the S/CL (around 5 hours).
Symptoms: Noticeable vibrations at idle, clunking under load changes, structure-borne noise in the cabin at low revs.
The V12 has two separate six-cylinder banks with numerous sealing surfaces. Valve cover gaskets start leaking from 80,000 km. Oil drips onto the hot exhaust — fire smell and smoke possible.
Symptoms: Oil smell after engine shutdown, oil mist in engine bay, oil drops under vehicle, burning smell from oil on exhaust.
The M279 uses twin-spark ignition with two plugs per cylinder — 24 in total. Replacement interval 60,000–90,000 km. Standard workshops often forget the second row. In cramped engine bays (S-Class, G-Class) accessibility significantly increases labour time.
Symptoms: When overdue: power drop, excess consumption, rough running, misfires on individual cylinders.
Vehicle Weaknesses 16
The active electro-hydraulic ABC suspension requires intensive maintenance. Hydraulic lines, valve blocks and pumps can develop leaks. Hydraulic oil change required every 50,000 km.
Air bags and pressure hoses develop leaks. The compressor runs continuously and overheats. Repair: air bag pair 2,500–3,500 €, compressor 1,000–1,300 €.
Air struts on Airmatic and Magic Body Control suspensions develop leaks. Vehicle drops, suspension warning light appears. Repair per corner is very costly.
The hydraulic Magic Body Control suspension is prone to valve block and hydraulic pump failures. Contamination in the oil causes system failures.
The COMAND infotainment system freezes sporadically or fails completely. System faults increase from around 100,000 km.
Radar and camera sensors for adaptive cruise control and emergency braking can cause malfunctions due to dirt or defects. Calibration after repair is expensive.
The COMAND navigation system shows read errors, freezes or fails to boot. A defective drive unit is the most common cause.
Panoramic roof drainage channels become dirty, rubber seals become brittle through UV radiation. Result: water ingress into the interior, particularly in the rear area.
Matrix LED headlights are not repairable -- individual modules cannot be replaced. Moisture and electronic failures require complete headlight replacement.
Window regulators fail or become unresponsive. Cause is often a software fault in the door control unit, fixable by update.
Brake discs and pads wear quickly due to the high vehicle weight. Particularly during spirited driving.
Frameless door windows are inherently harder to seal. Worn seals or minimal window misalignment cause wind whistling from around 80 km/h.
The pneumatic control unit operates soft-close, central locking and rear headrests via a shared pump. Leaks cause all functions to fail simultaneously.
The Comand NTG5 infotainment system shows display failures, freezing and navigation start errors. Temperature-dependent malfunctions occur frequently.
Seat heating mats and massage pneumatics in the multicontour seats are wear items. Heating mats fail internally, the PSE pump loses pressure for the massage function.
The rubber seal of the Keyless Go microswitch in door handles becomes brittle through UV and temperature cycling. Moisture enters, the switch corrodes.