Mercedes-Benz ML 420 CDI
Successor to the OM628, from 2005 with revised common rail injection at 1,600 bar and piezo injectors. Power output rose to up to 320 hp at 730 Nm — the gearbox hit its limits early, prompting Mercedes to recalibrate the NAG2 mapping during series production. Mechanically the OM629 shares most challenges with its predecessor but adds its own: the oil cooler in the V-area tends to leak at high mileages and additionally promotes EGR fouling of the intake tract. Cylinder heads come under extreme pressure during high-rpm full-load pulls — warped heads are not uncommon beyond 200,000 km. Piezo injectors demand clean fuel and short oil change intervals (10,000 km, 229.51 or 229.52). Anyone taking on this engine should budget for preventive oil cooler and seal replacement early on.
Sensible V8 Diesel SUV for High-Mileage Drivers
The ML 420 CDI hauls plenty, tows well, and is relaxed on the motorway — but it remains primarily a premium utility vehicle. If you want a V8 diesel SUV with a solid service history, this is a solid choice.
Engine Weaknesses 6
Warped cylinder heads allow combustion gases into the cooling system. Overpressure constantly pushes coolant out through the expansion tank. Engine runs at temperature, coolant level drops steadily -- replacement costs 5,000-16,000 EUR.
Symptoms: Coolant warning light despite stable engine temperature, coolant overflow from expansion tank, no visible external leak.
The NAG2 automatic transmission is rated for approximately 700 Nm; the OM629 delivers up to 730 Nm. Early build years without shift module adaptation showed driveshaft failures and gearbox problems. Later revised.
Symptoms: Shift jerks, gearbox fault messages, missed shifts, vibration on pull-away.
The oil cooler sits at the lowest point in the V-section of the engine and seals with rubber gaskets. At high mileages oil seeps out, pools in the V and drips down. Repair takes approximately 2 days.
Symptoms: Oil spots under the vehicle, oil mist in the V-section of the engine bay, elevated oil consumption.
The rear crankshaft oil seal leaks from approximately 200,000 km. The gearbox must be fully removed — substantial labour. Inspect the oil cooler at the same time and replace gaskets preventively.
Symptoms: Oil puddle under vehicle centre, oil film between engine and gearbox, oil loss without visible external source.
Intake manifold and inlet ports become heavily sooted through EGR recirculation. Engine oil from the V-area promotes coking. Simultaneous intake cleaning is mandatory during oil cooler repair.
Symptoms: Gradual power loss, increased fuel consumption, occasional lurching under load.
The OM629 uses piezo injectors at 1,600 bar injection pressure -- maintenance-intensive high-precision technology. With irregular servicing or fuel contamination, injectors wear prematurely.
Symptoms: Rough running, hesitation during cold operation, misfiring noises, black smoke.
Vehicle Weaknesses 7
Water enters through defective tail light seals and damages the rear SAM module. Mainly pre-facelift models up to 2008 are affected.
Airmatic air struts develop leaks, particularly at certain ride height settings. The compressor pumps continuously and eventually burns out.
The 7G-Tronic transmission control unit develops faults at higher mileages. Gear engagement becomes impossible, limp mode activates.
Aluminium steering rack bolts corrode due to road salt. If all three bolts fracture, power steering fails completely. KBA recall 012425.
Pressure reservoir, compressor and air bags are highly vulnerable. Vehicle drops on one side or completely. Repair costs are very high due to expensive original parts and high labour rates.
Brake lines under the rear axle are prone to corrosion, particularly in high-salt regions. Line clips encourage moisture accumulation. Replacement requires lowering the rear axle.
The rear SAM fails when water enters through tail lights. Result: failure of lighting, wipers and displays. Mainly pre-facelift models up to 2008 affected.