Citroën C3 Picasso
The EB2 NA (PureTech 82) uses an oil-bathed timing belt which has become the main weakness of this engine family. Fuel contamination of the engine oil through short-trip driving degrades the belt prematurely. PSA shortened the replacement interval multiple times; Stellantis switched to chain drive in successors.
Too little for the Picasso
82 hp naturally aspirated in the C3 Picasso — that gets tedious. Only acceptable for pure short-trip use.
Engine Weaknesses 6
The EB2 NA uses an oil-bath timing belt for valve timing. Fuel dilution from short-trip use degrades the oil and attacks the belt — it disintegrates into particles that clog oil galleries and ultimately cause belt snap and engine destruction. PSA reduced the replacement interval to 6 years/100,000 km.
Symptoms: Sudden engine failure without warning, particles visible in the oil during oil changes, oil pressure warning light, loud engine noises shortly before failure
Under frequent short-trip use, unburnt fuel from the injectors passes down the cylinder walls into the engine oil. The diluted oil loses its lubricating properties and significantly accelerates wet belt deterioration. With over 10% dilution an immediate oil change is required.
Symptoms: Fuel smell in engine oil, oil level appears to rise (dipstick shows more than filled), declining engine power, foamy or thin oil
The naturally aspirated EB2-NA 1.2 VTi also uses an oil-bathed timing belt. Belt particles contaminate the oil and block the oil pump. Stellantis extended the warranty to 10 years/180,000 km.
Symptoms: Oil pressure warning, belt fragment deposits visible in oil through the oil cap, engine shutdown on belt failure, no audible warning
EB2-NA engines can develop oil consumption of up to 3 l/1,000 km from around 80,000 km. Causes are worn piston rings and valve stem seals, which are accelerated by oil dilution from fuel.
Symptoms: Frequent oil top-ups required, blue smoke from exhaust at cold start or under acceleration, oil smell from engine breather
The water pump on the EB2-NA can fail together with the timing belt or leak independently. Since it should be replaced at every timing belt change, its condition is often neglected.
Symptoms: Slight coolant loss, temperature gauge fluctuates, coolant smell in engine bay, overheating warning on complete failure
Ignition coils on the EB2-NA 1.2 VTi can fail prematurely. Reports indicate that misfires persisted even after a timing belt change and were ultimately traced to a faulty ignition coil.
Symptoms: Stumbling under load, rough idle, engine check light, misfire fault codes P030x
